Step By Step How To Install Metal Roof

Work at a comfortable steady pace trying not to rip up or carry off too much old roofing at once.

Step by step how to install metal roof.

Remove the old roofing. You may also remove the old roof if you don t want it anymore. Next install the roofing underlayment. A typical metal roof installation can last anywhere from 30 to 50 years so you will have made an important investment in the value of your home.

Getting the right result will help you determine the right amount of metal roofing material you ll need to order. It is rarely used on residential roofs because it is harder to insulate properly. Learn how to install gable trim on a metal roof. Keep installing flashing around all the eaves.

If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. Don t worry if you don t own all of the tools needed to complete this diy project. Many corrugated metal roofing allows you to install it over the existing roof. Remove all the unwanted nails.

The next step is to learn more metal roofing installation. It is used mainly on sheds barns and similar buildings. Learn more about metal roof installation. Although you can install corrugated metal roofing over shingles for the best foundation it is recommended that all the old roofing be removed.

Trim the shingles away from the ridge vent hole. Rent tools and trucks for any project at the home depot. Corrugated metal roofing is either aluminum or galvanized steel. Re position the gutters if they are in the wrong place.

By following simple step by step instructions to installing a metal roof it s possible to keep your home completely safe from the elements wind rain snow hail. Try to remove the old roof on a sunny day. An excellent starting point would be to view our metal roofing installation guides. This guide will teach you about metal roof types and give you step by step instructions on how to install a metal roof.

Easy step by step article and video for gable and rake trim. Next you can start installing the metal flashing at the edges of the roof. The first step to installing a metal roof is to take an accurate measurement of your roof s height length and width. Installation of metal ridge cap isn t that difficult.

Attach the plastic ridge vent with 3 roofing nails. There are many corrugation patterns with the height and width of the peaks and valleys varying. Attach he ridge cap shingles with two nails each. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar.

After you watch the videos and read the article you should not have any problems. This is usually best laid out in horizontal format by nailing it in place until the whole roof area is covered up.