On the rake gable edges of the roof starter has 2 functions.
Starter row and first row of shingles on the roof.
Installed below the first row of shingles and along roof rake edges roof starters literally get your roof started in the right direction.
These shingles are instrumental in making sure the asphalt shingles are correctly laid out on your roof.
Snap a horizontal chalk line over the starting row to use as a guide.
If you are making your own starter shingles cut the tabs off for the starter course bottom row of shingles.
It is packaged two pieces per shingle 16 shingles per bundle.
Every roof has to start somewhere and that somewhere is at the appropriately named starter shingle also called starter strip.
Armour starter if you have selected iko s armourshake shingles for your roof you will need to use iko armour starter.
The continuous sealant ensures an effective seal between the starter and the first course of shingles.
Use the chalk line to snap a straight line vertically every 6 inches.
Lay the first row of shingles directly covering the narrow starter row.
Perforated down the center for easy separation.
First to provide a nice straight line to cut shingles on.
They re meant to be installed under the first row of roof shingles surrounding the perimeter of the roof.
Repeat this on both sides of the roof.
Every 5 inches make a new mark until you get to the rop of the roof.
Since that row doesn t have a shingle below it to protect the seams the starter shingles act as that barrier.
Place the glue strip at and all along the drip edge and the rake edges as well.
If these first shingles are not installed correctly there will be problems with the entire set of shingles.
Cut six inches off the length of the first starter shingle nailed on then use the rest of them full size.
Before you can begin setting asphalt shingles on your roof you must install a row of starter shingles.
Starter shingles are the initial shingle products installed on the roof just before the first course of the finish shingles which will comprise the visible parts of the roof.
Owens corning starter strip shingle helps save time by eliminating the need to cut shingles to create a starter row.
Use your chalk and tape measure to mark about 12 inches up on the roof for the first set of shingles.